Improve your spiritual life with the help of jewels


Glittery Holiday Acrylic Refrigerator Magnets

The glitter background on this magnet isGather the supplies listed above for this
bright and eye-catching from aproject. Use a permanent, solvent-based
distance--perfect for special holidays.craft ink with a solvent ink cleaner. Do not
Stamp out multiple holiday images on acrylicselect a stamp with words, as this project
squares and use different colors of glitterstamps on the opposite side of the finished
for variety. Attach a magnet to the outsideproduct, so any words would end up backwards.
of a gift with repositional double-stickAcrylic craft squares may be purchased at a
tape.Suppliescraft supply or rubber stamp store. The
double-sided super sticky tape is sometimes
Black  Craft  Inkcalled redline tape or tacky tape. Adhesive
magnet strip can be purchased in rolls at a
Scrap  Paperdiscount store and is easily cut with
scissors or a craft knife.Lay down some scrap
Rubber Stamp (1 1/2" graphic imagepaper to protect the work surface. Using a
recommended)permanent craft ink, stamp the image on the
acrylic square (if you have never used the
2"  x  2"  Acrylic  Craft  Squaresstamp before, try it out on a piece of scrap
paper first). Immediately clean the stamp.
Stamp  CleanerTap the cleaner on the rubber stamp and blot
on a paper towel. Repeat until no color
Paper  Towelsblots onto the paper towel. Scrub the rubber
stamp on a clean, dry paint pad to remove any
Paint  Pad  (optional)residue.Color in the stamped image with
acrylic paints or use permanent ink pens.
Acrylic  Paints  or  Permanent  Ink  PensAllow to dry or heat set.When the stamped
image is dry, pat the clear embossing inkpad
Fine  Paint  Brushon the side with the stamped image. When it
is thoroughly coated, sprinkle on the glitter
Clear  Embossing  Inkpadembossing powder. Tap off excess and return
to embossing powder container. Heat set the
Glitter  Embossing  Powderembossing powder with the heat gun.After the
embossing powder has cooled, apply the tacky
Craft  Heat  Guntape to the edge of the acrylic square,
keeping the edge centered on the tape. Cut
Card  Stock  (at  least  2"  x  2")the tape so that it wraps all the way around
the square. Carefully fold edges over while
Craft  Kniferemoving the protective backing. Lay the
card stock on the cutting mat. Place acrylic
Cutting  Matsquare stamped-side down on the card stock.
Holding the acrylic square steady with one
1/4" to 3/8" Width Double-sided Super-stickyhand, trim the card stock with the craft
Tapeknife. Cover the remaining exposed tape with
glitter or tiny glass beads, pressing firmly.
Glitter  or  Tiny  Glass  BeadsHeat set the glitter into the tape with the
heat gun. Lastly, cut a piece of adhesive
Adhesive  Magnet  Stripmagnet strip, remove the protective backing
and stick to the back of the magnet.



1 A B C D E 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 112 113 114 115 116 117